#1 Roulette Forum & Message Board | www.RouletteForum.cc

Roulette-focused => Testing zone => Topic started by: VIP on Jan 12, 01:21 PM 2011

Title: The correct way to test your system
Post by: VIP on Jan 12, 01:21 PM 2011
When we make or buy or find a system we do not have to start testing it in RNG or live spins.
This will just be a waste of time because it can start losing after a lot of testing spins...

The only way to test your system is this :

1)Look at the system and calculate with which way the system can lose a session.(for this we don't need any spins to test...it is just a preview.)

2)If the system Worth(because it is passing the 1st rule) calculate with a hell session that you will make on your own and see the loss and calculate how many sessions you must win in order to overcome this loss.


We know and we have seen that Randomness can make any pattern and give any results.
So we do not need any spins to test...before we are satisfied of passing the 2 rules above.
If the systems pass the 2 rules then we can test if we like.

My suggestions is for the 1st rule to find a very rare thing to happen and then engineer a system on it....

e.g.. the way to lose a session:
a)If there will be less then 18/60 of an EC
b)If the law of the third will fail
Etc.....

My suggestion for the 2ND rule is that the system must not need more than 200 chips.
Simply because it will be very hard to overcome in the next sessions .

This was my lights for you

Thank you.